Replacement straps must be heated in order to stretch
them onto the furniture frame. We recommend that you
wear gloves to protect your hands.
.

Step 1: Heat the VINYL Strap

Heat a large pot of water to just under the boiling
point. Roll a strap and heat it in the pot for approximately two minutes. Remove the strap with a pair of tongs, and dry it with a towel.

Step 2A: Strapping - Single-wrap

Single-wrap method. Push a single-wrap pin thru each
end of the vinyl strap. Position one end of the strap
at a hole on the frame. Push the pin through the hole
until it locks (Figure 1). Stretch the strap around
the front to the corresponding hole on the right side
of the furniture (Figure 2); push the remaining pin
through the hole on the backside of the frame, and
lock it into place (Figure 3).

STEP 2B: STRAPPING - DOUBLE-WRAP

Double-wrap method. Push a double-wrap pin into each
end of the strap. Position one end of the strap at a
hole on the frame (Figure 1), and push the pin through
the hole. Wrap the strap around the bar once (Figure
2), covering the double-wrap pin (Figure 3).

Stretch the strap around the front to the right side
of the furniture below the corresponding hole (Figure
4), then wrap around the frame upward towards the hole
(Figure 5). Push the pin into the hole (Figure 6).
Adjust the strap (Figures 7 and 8).

FIGURE 1

FIGURE 2

FIGURE 3